Loft Tank Leaking or Overflowing? Causes and Fixes

A leaking or overflowing loft water tank is usually down to a worn ball valve, a blocked overflow, or frost damage. This guide explains how to spot the cause, what a vented system needs, and when to call in a survey.
loft tank leaking — The Tank You Forgot Until the Ceiling Spoke (Scotland Leak Detection)

Last updated: 11 October 2026 — Scotland Leak Detection

Quick Answer

A loft tank leaking or overflowing is usually a worn ball valve that won’t shut off, a blocked overflow pipe, or a split from age or frost. Check the ball valve first. If the tank or its pipework is damaged, or you can’t find where water is escaping, a non-invasive survey will trace it without lifting the loft floor.

What a loft tank actually does

Plenty of Scottish homes, especially older tenements and traditional properties, still run a vented system with a cold water storage tank in the loft. The tank feeds the hot water cylinder and sometimes the cold taps too, working on gravity rather than mains pressure alone.

Because it sits above living space, a fault up there doesn’t stay contained. Water finds the path of least resistance downward, through joists, insulation and then a ceiling. By the time you see a stain or hear dripping, the tank has often been letting go for a while.

Most vented systems actually run two tanks in the loft rather than one: a larger cold water storage tank supplying the taps and cylinder, and a smaller feed-and-expansion tank topping up the central heating circuit. They look similar and sit close together, so it’s worth checking which one is actually causing the problem before assuming it’s the main tank. A feed-and-expansion tank that won’t stop filling points to a heating system fault rather than anything to do with your cold water supply.

The tank’s age matters more than people expect. Galvanised steel tanks fitted decades ago were built to last, but corrosion works from the inside out, so a tank can look sound on the outside while thinning badly at the base. Plastic tanks fitted since the 1980s don’t corrode the same way, but the fittings where pipes pass through the tank wall are still a common failure point after twenty or thirty years of expansion and contraction.

The ball valve: the usual suspect

The ball valve (or float valve) shuts off the water supply once the tank reaches the right level. It’s a mechanical part with a washer that wears out, and it’s the single most common reason a loft tank leaks or overflows.

What wear looks like

A worn washer stops the valve sealing fully, so water keeps trickling in even once the tank is full. That extra water has to go somewhere, usually straight out the overflow pipe.

What a stuck float looks like

If the float arm has bent, corroded, or the float itself has filled with water and sunk, the valve never registers "full" and keeps letting water in continuously.

Honestly, most of the time it’s the ball valve. Replacing one is a straightforward job for a plumber and rarely needs any specialist detection work, it just needs someone to actually get up there and look.

Overflow pipe running constantly

The overflow pipe is a safety feature, designed to carry excess water outside if the tank overfills, rather than let it spill inside the loft. If you’ve noticed water dripping from a pipe outside, under the eaves, that’s the overflow doing its job. It’s a symptom rather than the cause.

A constantly running overflow almost always traces back to the ball valve above. Occasionally the overflow pipe itself is blocked or has come loose at a joint, which sends water into the loft space instead of outside where you’d notice it straight away.

loft tank leaking — older pipework (Scotland Leak Detection)

Older pipework hides the source

In older Scottish properties, loft pipework has often been extended, patched or rerouted over the decades. That makes it harder to trace an overflow or a joint failure back to its actual source just by looking. A thermal or acoustic survey can follow the pipe run and show exactly where water is escaping, rather than guessing from a stain two rooms away.

Frost, splits and old age

Older galvanised steel and early plastic tanks corrode or become brittle with age, and a hairline split can appear at a seam or around a pipe connection. Frost makes this worse: if the loft gets cold enough, water at the tank’s edges can freeze, and the expansion puts stress on a tank that’s already had thirty winters behind it.

If your loft tank is original to a property built decades ago, don’t wait for a full failure. A tank that splits at 2am on a cold night sends a lot of water through your ceiling before anyone’s awake to stop it.

Insulation and winter exposure

The tank and its pipework need insulation, but done the right way round: sides and pipework wrapped, top left loosely covered so a little rising heat still reaches the water. Fully sealing the top actually increases freeze risk, because it blocks the small amount of warmth escaping from the rooms below.

Scottish Water’s winter advice for homeowners is to heat, insulate and protect: keep some background heating running, insulate exposed pipes and tanks, and take extra care with a property that’s left empty. Scotland recorded around 3,100 burst pipes in winter 2023/24, and pipework connected to loft tanks is a regular contributor to that number.

Loft tank causing damp patches you can’t explain?

If you’ve fixed the obvious ball valve issue and the ceiling’s still staining, we can trace exactly where the water is coming from without opening up your loft floor.

When it’s not the tank at all

Sometimes what looks like a leaking loft tank is actually a pipe joint nearby, a failed connection on the vent pipe, or condensation dripping from cold pipework onto insulation below. All of these show up as the same damp patch on a ceiling, so it’s worth ruling out the actual tank before assuming it needs replacing.

This is where plumbing leak detection earns its keep. Rather than pulling up boards across the whole loft floor to search by eye, a survey uses thermal imaging and moisture readings to narrow the search down to the actual joint or split, often in an hour or two. That matters if the tank sits above a room you don’t want disturbed, or if you’re getting a home report done and need documented findings.

Kitchen sink leaks, airlocks and under-bath access issues all get confused with a loft tank problem too, since water travelling through a ceiling doesn’t always start where the stain appears. If you’re dealing with a kitchen sink leaking underneath, that’s usually unrelated plumbing entirely, but worth ruling out before you assume it’s the tank above.

3,100+ pipe bursts across Scotland in winter 2023/24, Scottish Water reported
30%+ of those bursts were on customer-owned property, not the mains
£10,000 average burst-pipe insurance claim, according to insurer NFU Mutual

A loft tank sits right at the intersection of most of those figures: it’s in an unheated space, it’s often original to the property, and its failure mode (a split or an overflow that won’t stop) is exactly the kind of slow, avoidable damage those numbers describe. Checking it each autumn alongside your pipe lagging takes a few minutes and costs nothing.

If your property has shared ownership, such as a tenement close where the tank feeds more than one flat, responsibility for repairs is shared according to the title deeds, or the statutory Tenement Management Scheme where the deeds are silent on the point, according to Citizens Advice Scotland. Worth checking before you assume it’s a one-owner job.

Frequently Asked Questions

Q: Why does my loft tank keep overflowing?

A worn ball valve washer or a stuck float is the most common cause. Water keeps entering the tank even once it’s full, and the excess exits through the overflow pipe. Replacing the ball valve usually solves it and is a routine job for any plumber.

Q: Is a dripping overflow pipe an emergency?

Not usually, since the overflow is designed to carry excess water safely outside. It’s worth fixing promptly, though, because the underlying valve fault will keep wasting water and can eventually cause the overflow itself to fail or freeze shut in winter.

Q: How do I know if my loft tank has actually split?

A split tank usually shows as damp appearing suddenly in a ceiling below the loft, rather than a slow drip that comes and goes. If you can safely check the loft, look for water pooling around the tank’s base or staining down its sides.

Q: Can I replace a loft water tank myself?

It’s possible but involves isolating the supply, disconnecting several pipe connections, and manoeuvring a full-size tank through a loft hatch. Most homeowners get a plumber in for this, particularly in older properties where pipework is original and fragile, and where a mistake can mean water damage on the floors below.

Q: Do modern combi boiler homes still have a loft tank?

Usually not. Combi boilers heat water on demand from the mains and don’t need a cold water storage tank. Loft tanks are mainly found in older properties with a vented hot water cylinder system, common across older Scottish housing stock.

Q: Why is water coming through my ceiling but the loft looks dry?

Water can travel along a joist or pipe run before dripping through the ceiling at a point some distance from the actual leak. A survey traces the path rather than relying on where the stain appears to be. Moisture readings across the ceiling narrow down the true source quickly.

Don’t let a small problem become a big one

A slow loft tank leak can sit undetected for months. Our non-invasive surveys pinpoint the source fast and give you an insurance-ready report.